What Problems Should Be Paid Attention To When Installing The Dropper Belt

Dropper belt is a commonly used equipment in water-saving irrigation, which can realize the integrated irrigation of water and fertilizer at a lower cost. We need to install the equipment before using it. The quality of the installation operation will directly affect the use effect of the equipment. Therefore, we should install it according to the relevant requirements, and pay attention to the following points when installing the equipment:

1. The guide wheel of the device for laying the drip irrigation belt should be flexibly rotated, the guide ring should be smooth, and the thin wall should be wrapped as much as possible to avoid the equipment being scratched or worn during the laying.

2. The laying of the equipment should not be too tight, and a certain margin should be left to facilitate free expansion and contraction, so as to prevent the installation from being too tight and difficult to install; at the same time, it should not be too loose to avoid waste.

3. When laying the single-wing labyrinth equipment, the runner should be raised up.

4. After the laying device enters the working state, it is strictly forbidden to go backwards.

5. During the laying process, the disconnected position should be connected in time to avoid the entry of sand and other debris.

The installation of the dropper belt is very important. We should operate according to the above requirements when installing the equipment. If there is a problem during the installation process, we should respond in time to ensure that the installation quality of the equipment passes the test, thereby improving the use effect of the equipment.